Air Cleaner Housing: Locations

Air Filter, Assembly Overview

Connection to compressor for air suspension , separating







1. Air duct
- Secured to lock carrier
2. Protective grommet
3. Air filter lower part
- To remove air filter lower part, remove bracket
4. 10 Nm
5. Filter element
6. Air filter upper part
7. Seal
- Replace if damaged
8. Mass Air Flow (MAF) Sensor G70 with Intake Air Temperature (IAT) Sensor G42
- Sensor contacts and connector contacts gold plated
- Black connector, 5-pin
9. 6 Nm
10. Spring-type clip
- Check for secure seat
11. Intake tube
12. To Throttle Valve Control Module J338
13. To compressor for air suspension
- Separating connection
- Depending on optional equipment, connection may be sealed with a blanking plug.
14. Heat shield
- For upper part of air filter
15. 6 Nm

16. To Secondary Air Injection (AIR) Pump Motor V101







Removing bracket for engine cover
- Press in retaining tab - 1 - from below and pull out bracket in direction of - arrow -.

Connection to compressor for air suspension, separating







- Separate connecting line at air filter - arrow - as follows:
- Carefully pry off green circlip - 1 - using a screwdriver. Then press clamping ring - 2 - in direction of - arrow - .








- Pull only loosened line - B - from connection - A - at air filter.