Ignition System: Locations

Ignition System Components, Assembly Overview







1. Ignition coil with power output stage N70, N127, N291, N292, N323, N324
- Remove and install using Puller For Ignition Coil T10095 A
2. Connector
- Black, 4-pin
- Use assembly tool T10118 to pull off
3. Bracket
- For harness connector of Knock Sensor (KS) 1 G61
4. 10 Nm
5. Connector
- Black, 3-pin
- Sensor contacts and connector contacts gold plated
6. Knock Sensor (KS) 1 G61
- Component location: Between cyl. 1 and cyl. 3
7. 20 Nm
- Torque setting influences function of knock sensor
8. Exhaust camshaft adjuster
- Identification: 32A
- With sensor wheel for Camshaft Position (CMP) Sensor 2 G163
- If camshaft adjuster has been removed, adjust valve timing after installation.
9. Cover
10. Seal
- Replace
11. Camshaft position (CMP) sensor 2 G163
- For exhaust camshaft
- Sensor contacts and connector contacts gold plated
12. 10 Nm
13. Connector
- Black, 3-pin
- Sensor contacts and connector contacts gold plated
- Mark connector before removing
14. Camshaft Position (CMP) sensor G40
- For intake camshaft
- Sensor contacts and connector contacts gold plated
15. Knock Sensor (KS) 2 G66
- Component location: Between cyl. 4 and cyl. 6
- Sensor contacts and connector contacts gold plated
16. Connector
- Black, 2-pin
- Sensor contacts and connector contacts gold plated
17. Intake camshaft adjuster
- Identification: 24E
- With sensor wheel for Camshaft Position (CMP) Sensor G40
- If camshaft adjuster has been removed, adjust valve timing after installation.
18. Spark plug, 20 Nm
- Removing and installing with spark plug removal tool 3122B
- Type and electrode gap
19. Control housing
- Camshaft adjustment valves, removing and installing