Access/Start Authorization Control Module

Access/Start Authorization Control Module

• Perform the following procedure if the control module will be replaced:

• with immobilizer through 11.06 --> [ Access/Start Authorization Control Module, Replacing ] Immobilizer, through 11.06

• with immobilizer from 12.06 --> [ New Access/Start Authorization Control Module ] Immobilizer, from 12.06 or --> [ Used Access/Start Authorization Control Module ] Immobilizer, from 12.06

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove the driver lower storage compartment

- Remove the bolt - arrow - and the ventilation duct - 1 -.





- Press both retaining tabs - 2 - apart and pivot the access/start authorization control module - 1 - out of the bracket in the - direction of the arrow -.





- Remove the access/start authorization control module - 1 - downward from the bracket. Be careful of the connected wires.





- Release and disconnect both connectors - arrows - and remove the access/start authorization control module - 1 - from the vehicle.

Installing

Install in reverse order of removal, noting the following:

- Connect both connectors on the access/start authorization control module.

- First insert the access/start authorization control module - 1 - in the top of the duct - A - and then press it into the retainer - B -.





- Make sure the control module engages correctly in its bracket.