Safety Precautions

Safety Precautions

To reduce the risk of personal injury and/or damage to the fuel injection and ignition system, always observe the following:

• Only disconnect and reconnect wires for injection and ignition system, including test leads, when ignition is switched off.

• Do not touch or remove ignition wires when engine is running or turning at starter speed.

If test and measuring equipment is required during road test, note the following:

• Test and measuring instruments must be secured to rear seat and operated by a 2nd person from this location.

If test and measuring instruments are operated from the front passenger's seat and the vehicle is involved in an accident, there is a possibility that the person sitting in this seat may receive serious injuries when the airbag is triggered.

If the engine is to be turned at starter speed, without starting: Disconnect connectors from ignition coils 1 to 6. assembly tool (T10118) can be used to release locking mechanism.

- Place the assembly tool (T10118) against the release button - arrow -, and carefully remove the connector from the respective ignition coil with power output stage.