Bonded Rubber Bushing In Transmission Carrier, Replacing

Bonded rubber bushing in transmission carrier, replacing





Special tools, testers and auxiliary items required
^ Pressure plate VW 402
^ Punch VW 412
^ Thrust plate VW 432
^ Base block VW 441
^ Tube 3296
^ Alignment fixture T10214

- Remove transmission carrier.





- Pressing out bonded rubber bushing.





- Connect new bonded rubber bushing with pressure piece T10214/3.
- Press new bonded rubber bushing - A - with pressure piece T10214/3 into guide sleeve T10214/2, until pressure piece T10214/3 is flush with guide sleeve T10214/2.





- Align bonded rubber bushing to transmission carrier, using assembly tool T10214.
- To align bushing, align bolts - A - and/or notch - arrow - on pressure piece T10214/3 centrally to holes in transmission carrier.

Spacing "x" must be equal.





- Press bonded rubber bushing into transmission carrier, until guide sleeve T10214/2 can be turned by hand - arrows -.

Do not press the bonded rubber bushing any deeper into the transmission carrier than the height of the tube 3296. If necessary press further with base block VW 441 up to stop.
- Install transmission carrier.