Engine Assembly - Fastener Tightening Specifications

Fastener Tightening Specifications






Engine Mount





A = 20 Nm + 90° (1/4) additional turn 1

B = 40 Nm + 90° (1/4) additional turn 1

C = 60 Nm + 90° (1/4) additional turn 1

Transmission Mount





1 = 40 Nm + 90° (1/4 turn) additional turn 1

2 = 60 Nm + 90° (1/4 turn) additional turn 1

Pendulum Support





• First, install pendulum support bolt to the transmission and then to the subframe.

A = Strength category 8.8 = 40 Nm + 90° (1/4) additional turn 1

A = Strength category 10.9 = 50 Nm + 90° (1/4) additional turn 1, 2

B = 100 Nm + 90° (1/4) additional turn 1

• 1 Always replace

• 2 With a manual transmission, only use bolts with a strength category of 10.9 if threaded inserts (for example, Heli-Coil) are installed. Identification: Section - arrow - on the first thread.