Exterior Moulding / Trim: Service and Repair

Cover strip

Optional Equipment Depending on Country

• The covers cannot be removed without damaging them.

• The assembly procedure describes the left cover strip. The procedure for the right cover strip is the same.

Cover Strip Installation Instructions

• Warm the cover strip with a hot air blower (V.A.G 1416).

• If removing the cover strip, only use the adhesive remover (D 002 000 10) to remove the adhesive residue.

• Remove any adhesive residue left by the tape using adhesive remover (VAS 6349).

• Make sure the adhesive surfaces are free of dust and grease.

• Apply the sealing lip immediately after cleaning.

• Only remove the protective film right before assembly.

• Temperature approx. 70°F (21° C).

• The covers cannot be removed without damaging them.

Removing






- Warm the front cover strip - 1 - with the hot air gun (V.A.G 1416) and remove it from the sill panel - 2 -.

Installation

- Remove the protective film from the new cover strip - 1 -.

- Position the cover strip - 1 - and glue it to the sill panel - 2 -.