Rollover Protection

Rollover Protection


Observe safety measures and notes for work on rollover protection. Refer to => [ Rollover Protection Safety Precautions ] Rollover Protection Safety Precautions

Removing

- Open roof completely.

- Disconnect the battery.

- Remove the seat bench. Refer to => [ Bench Seat ] Bench Seat

- Remove headrest covers. Refer to => [ Headrest Cover ] Headrest Cover.

- Remove the backrest. Refer to => [ Backrest ] Backrest

- Remove side trim. Refer to => [ Side Trim ] Side Trim

- Remove rear seat belt anchors. Refer to => [ Rear Seat Belt Anchors ] Rear Seat Belt Anchors

- Remove the rollover protection trim. Refer to => [ Rollover Protection Trim ] Rollover Protection Trim

- Remove rollover protection trim support piece. Refer to => [ Rollover Protection Support Trim ] Rollover Protection Support Trim

- Operate the respective catch on the corresponding connector and disconnect wiring harnesses from Driver's Rollover Protection Solenoid (N309) and Front Passenger's Rollover Protection Solenoid (N310).

- Remove a total of twelve screws - 1 - (28.5 Nm) and remove right - 2 - and left rollover protection - 3 - from mounts in body.






Installation

- Install in reverse order of removal.

- Turn on the ignition.


Ensure there are no people in rollover protection deployment area.

- Connect the battery.