Rollover Protection Trim

Rollover Protection Trim

Removing

- Open roof completely.

- Remove the seat bench. Refer to => [ Bench Seat ] Bench Seat

- Headrest covers, removing and installing, refer to => [ Headrest Cover ] Headrest Cover

- Remove the backrest. Refer to => [ Backrest ] Backrest

- Remove side trim. Refer to => [ Side Trim ] Side Trim

- Remove rear seat belt anchors. Refer to => [ Rear Seat Belt Anchors ] Rear Seat Belt Anchors

- Remove both securing clips - 1 -.

- Remove center rollover protection trim - 2 - up out of mounts.

- Remove the two screws - 3 - (1.5 Nm) and remove right rollover protection trim - 4 - up out of mounts.

- Thread seat belt with belt anchor through slit in trim.

- Remove the two screws - 5 - (1.5 Nm) and remove left rollover protection trim - 6 - up out of mounts.

- Thread seat belt with belt anchor through slit in trim.






Installation

• Check the fasteners for damage and replace if necessary.

- Install in reverse order of removal.