Rear Window Frame Opening Sensor

Rear Window Frame Opening Sensor






- Open roof via convertible top operating switch until rear lid tips back.

- Place Hinge Supports (VAS 6365) in center position - 2 -.

- Secure Hinge Supports (VAS 6365) on rear window frame locking mechanism - 1 -.

- Open bypass screw on hydraulic pump.

- Lower rear window frame until supports - 4 - are positioned on longitudinal member - 5 -.

• All screws are microencapsulated and must always be replaced.






- Remove screw - 2 - and remove sensor - 1 - from main hinge - 4 -.

When replacing sensor, disconnect wire - 3 - approximately 220 mm from sensor, behind corner. Wiring harness repair description. After repairing wiring harness, wiring must be secured in harness again.

Tighten screws - 2 -: 3 Nm.