Cornering Lamp and Headlamp Range Control Module (J745)

Cornering Lamp and Headlamp Range Control Module (J745)

Special tools, testers and auxiliary items required

• Trim Removal Wedge (VAS 3409)

• When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool ( (VAS 3409) , screwdriver) will be positioned, using commercially available adhesive tape.

Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove side cover - 1 - of instrument panel, do this by inserting (VAS 3409) or a screwdriver into recess - 2 - and pry off cover - 1 - in - direction of arrow -.






- Disengage securing bracket - 1 - in - direction of arrow - and disconnect harness connector - 2 - from Cornering lamp and headlamp range control module (J745).






- Remove mounting bolt - arrow - and remove Cornering lamp and headlamp range control module - 1 - from bracket - 2 -.






Installation

Install in reverse order of removal, noting the following:

- Insert Cornering lamp and headlamp range control module- 3 - with retaining clip - 2 - in bracket - 1 -.






- Engage harness connector - 1 - by pressing securing bracket - 2 - in the - direction of the arrow -.






• After installing a new Cornering lamp and headlamp range control module (J745) , it must be coded. Refer to => [ Coding ] Coding.