Diode Circuit Board For Side Panel Tail Lamp

Diode Circuit Board For Side Panel Tail Lamp

• Illustrations depict removal and installation of the left side. Removal and installation of the right side is performed symmetrically.






1 Tail Lamp Housing

• Removing and installing tail lamp, refer to => [ Tail Lamps in Side Panel ] Tail Lamps in Side Panel.

2 Screw

• 2 Nm

• tightening specifications overview, refer to => [ Tail Lamps In Side Panel, Tightening Specifications ] Tail Lamps In Side Panel, Tightening Specifications.

3 Side marker light with left rear side marker lamp bulb (M37) and right rear side marker lamp bulb (M38)

• For USA and Canada markets

4 Screw

• 1 Nm

• tightening specifications overview, refer to => [ Tail Lamps In Side Panel, Tightening Specifications ] Tail Lamps In Side Panel, Tightening Specifications.

5 Gasket

• ensure it is seated correctly

6 Screw

• 1.5 Nm

• Quantity: 3

• tightening specifications overview, refer to => [ Tail Lamps In Side Panel, Tightening Specifications ] Tail Lamps In Side Panel, Tightening Specifications.

7 Gasket

• Replace damaged gasket

8 Cover

• Note installed position!

9 Gasket

• Replace damaged gasket

10 Diode circuit board

• Installation position maintained by securing pins - arrows A -, is clipped in on tail lamp housing.

• Note installed position!

11 Flange nut

• 3 Nm

• Quantity: 2

• tightening specifications overview, refer to => [ Tail Lamps In Side Panel, Tightening Specifications ] Tail Lamps In Side Panel, Tightening Specifications.