Variable Induction Control Module: Service and Repair

Throttle Valve Control Module

Removing

- Pull off the air guide cover - 1 -, disengage the clips sideways to do so.






- Unclip the air duct - 2 -.

- Remove the air filter housing and connecting hose, while doing this remove the bolt - A -, disconnect the connector - B - and remove the spring clip - C -. When re-installing, observe the mark - D -.






- Disconnect electrical connection to the throttle valve control module (J338).

- Remove the throttle valve control module - arrows - from intake manifold.






Installing

Installation is performed in the reverse order of removal, noting the following:

- If a new throttle valve control module was installed, adapt the Engine Control Module (ECM) to the throttle valve control module. Refer to "Guided Functions" in the vehicle diagnostic tester.