Oil Pan Overview

Lubrication System Overview





Oil Pan Overview





1 Bolt

• 15 Nm

2 Oil Dipstick

• Marks, refer to => [ Marks on the Oil Dipstick ] Description and Operation.

• Oil level must not be above the Max. mark!

3 Inlet Spout

4 Guide Tube

5 Intermediate Plate

6 Oil Pump with Balance Shaft Drive

• With pressure relief valve 12 bar.

• Removing and installing, refer to => [ Oil Pump with Balance Shaft Drive ] Oil Pump with Balance Shaft Drive.

7 Bolt

• 15 Nm + 90° (1/4) additional turn

• Replace

• Note the different length of bolts, refer to => [ Balance Shaft Drive
Bolt Allocation ] Oil Pump with Balance Shaft Drive.

8 Bolt

• 15 Nm

9 Bolt

• 8 Nm

• For the charge air pipe.

10 Oil Pan

• Clean the sealing surface before installing.

• Removing and installing, refer to => [ Oil Pan ] Oil Pan.

11 Bolt

• 15 Nm

12 Oil Drain Plug

• 30 Nm

• Replace

• With a permanent seal.

13 Oil Pump Chain Sprocket

14 Bolt

• 10 Nm

• Does not apply to this engine in the US.

15 Protective Cap

• Does not apply to this engine in the US.

16 Oil Level Thermal Sensor (G266)

• Does not apply to this engine in the US.

17 Seal

• Replace

• Lubricate before assembling.

• Does not apply to this engine in the US.

18 Bolt

• 20 Nm + 90° (1/4) additional turn

• Replace

19 Chain Guard

20 Chain

21 Sealing Flange

• Must be located on the alignment pins.

• Removing and installing, refer to => [ Sealing Flange, Belt Pulley Side ] Sealing Flange, Belt Pulley Side.

• To remove and install, remove the oil pan. Refer to => [ Oil Pan ] Oil Pan.

• Seal, belt pulley side, replacing. Refer to => [ Seal, Belt Pulley Side ] Service and Repair.