Evaporative Emission System Assembly Overview

Evaporative Emission System Assembly Overview





1 Fuel Tank

2 Vent Line

• Behind the wheel housing liner.

3 Vent Line

• On the vehicle floor.

4 Vent Line

• To the Evaporative Emission (EVAP) canister purge regulator valve at the intake manifold.

• To remove, press the release button.

5 Bolt, 8 Nm

6 Evaporative Emission (EVAP) Canister

• Component location: Bottom of the spare tire wheel well.

• Removing and installing, refer to => [ EVAP Canister ] Service and Repair.

7 Connecting Pipe

• Pressure side.

• On the vehicle floor.

8 Connecting Pipe

• Pressure side.

• Behind the wheel housing liner.

9 Bolt, 3 Nm

10 Air Filter Housing

• For the Leak Detection Pump (LDP)

11 Connecting Hose

• Intake side.

12 Bracket

• For the LDP.

• Mounted under the wheel housing liner.

13 Bolt, 2 Nm

14 Nut, 6 Nm

15 Leak Detection Pump (LDP) (V144)

• Component location: Under the wheel housing liner in the right rear wheel housing.

• Removing and installing, refer to => [ Leak Detection Pump ] Service and Repair.

• Fuel system, checking for leaks. Refer to => [ Fuel/EVAP System, Checking for Leaks ] Testing and Inspection.

16 Connector

• Black, 3 pin.

17 Vacuum Line

• From the intake manifold.