Brake Pedal

Brake Pedal

Removing

- Remove trim below instrument panel.

- Remove bolts - 1 -.





- Remove cover - A -.

- For vehicles with manual transmission, remove connecting sheet between clutch and brake pedal.





- Remove brake light switch - 1 - on vehicles up to 02.00 by rotating 90 degrees toward left.

- Remove brake light switch - 1 - on vehicles from 03.00 by rotating 45 degrees toward left.

- Remove brake light switch - 1 - on vehicles up to 11.06 by rotating 90 or 45 degrees toward left.

- Remove brake light switch - 1 - on vehicles from 11.06 by rotating 45 degrees toward left.

- Disengage accelerator pedal cable.

- For vehicles with sensor for accelerator position, disconnect harness connector below instrument panel.

- Disconnect brake pedal from brake booster => [ Brake Pedal to Brake Booster, Disconnecting and Connecting ] Brake Pedal to Brake Booster, Disconnecting and Connecting.

- Remove hex nuts => [ (Item 2) Self-locking hex nut, 20 Nm ] Brake Pedal Assembly Overview.

- Remove pedal assembly.

- Remove brake pedal.

Installing

Installation is performed in reverse order of removal.

- Adjust brake light switch for vehicles from 03.00 => [ Brake Light Switch, Adjusting, from 03.00 ] Adjustments.

- Adjust and lock brake light switch for vehicles up to 11.06 => [ Installing, adjusting and locking ] Brake Light Switch, Through 11.06.

- Adjust and lock brake light switch for vehicles from 11.06 => [ Installing, adjusting and locking ] Brake Light Switch, From 12.06.