Removal and Replacement

Hydraulic System Component Overview





1 Brake fluid reservoir

2 Supply hose

3 Clutch master cylinder

• Removing and installing => [ Master Cylinder ] Service and Repair.

4 Retainer

• Replace only with master cylinder removed

5 Clutch pedal

• Removing and installing => [ Clutch Pedal ] Clutch Pedal.

6 Self-locking hex nut, 25 Nm

• 2x

• For master cylinder and mounting bracket to bulkhead

• Always replace

7 Seal/O-ring

• Always replace

• Install on line connection

• Insert with brake fluid

• Seals/O-rings matched to material of line connections => [ Seals/O-rings for hose/line assemblies ]

8 Hose/line assembly

9 Bracket

• Secured to chassis

10 Seal/O-ring

• Always replace

• Install on line connection

• Insert with brake fluid

• Seals/O-rings matched to material of line connections => [ Seals/O-rings for hose/line assemblies ]

11 Clip

• To remove and install hose/line assembly, pull off clip until stop

12 Clutch slave cylinder

• Removing and installing => [ Slave Cylinder ] Service and Repair.

13 Hex bolt, 20 Nm

14 Bleeder valve

• Clutch system, bleeding => [ Clutch System, Bleeding ] Procedures.

15 Dust cap

16 Transmission

17 Bracket

18 Hex bolt, 20 Nm

19 Clip

• To remove and install hose/line assembly, pull off clip until stop

Pry off retainer - A - in direction of - arrow -





Press master cylinder operating rod in retainer- A - in direction of - arrow -





Seals/O-rings for hose/line assemblies