Front Parking Aid Sensors

Parking Aids

Front Parking Aid Sensors

Removal and installation of parking aid sensors in bumper and radiator protective grille is performed in the same way.

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

- Remove radiator protective grille.

- Remove front turn signal. Refer to => [ Front Turn Signals ] Front Turn Signals.

- Disengage and disconnect harness connector - 3 -.





- Press both retaining lugs - 2 - on sensor bracket outward and pull parking aid sensor - 1 - toward rear out of sensor bracket.

• When removing sensor, make sure that the sensor de-coupling ring (black silicone ring) does not remain in the sensor bracket.

Installing:

Install in reverse order of removal, noting the following:

• When inserting sensor into sensor bracket, make sure that de-coupling ring (black silicone ring) has proper fit on the sensor head.

• Both sensor bracket retaining clips must engage audibly when installing sensor.