Rearview Camera System Control Module

Parking Aids

Rearview Camera System Control Module

Control module is installed in luggage compartment behind right side wall trim.

The following describes the assembly procedure for the wagon. Adapt the steps as needed for the sedan.

Removing:

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove the luggage compartment cover and screen separator if necessary.

- Remove the lock carrier cover in the luggage compartment.

- Remove both tie down eyes - arrows -.





- Unclip the side trim at the locations marked with - arrows -.





- Raise the side trim from the guide near the window.

- Carefully press the side trim in the - direction of the arrow -.





- Release and disconnect both connectors - 1 - and remove the control module - arrow - from the retainer.





Installing:

Install in reverse order of removal.

Only if the control module has been replaced:

- Calibrate the system again, refer to => [ Rear View Camera System, Calibrating ] Component Tests and General Diagnostics.