Sun Shade

Rear Shelf

Sun Shade

Removal

• Removal of sun protection shade is performed when it is in a rolled in state.

- Remove trim on C-pillars, sedan:

• Vehicles without sun shade, refer to => [ C-Pillar Trim without Sun Shade ] Pillar Trim

• Vehicles with sun shade, refer to => [ C-Pillar Trim with Sun Shade ] Pillar Trim

- Remove seat bench. Refer to => [ Seat Bench ] Rear Seats.

- Remove side upholstery:

• with rear side airbags, refer to => [ Side Upholstery with Side Airbag ] Rear Seats

• without rear side airbags, refer to => [ Side Upholstery without Side Airbag ] Rear Seats

- Remove rear shelf (vehicles with sun shade). Refer to => [ Rear shelf with Sun Shade ] Rear Shelf With Sun Shade

• Removal is described for the left side of the vehicle, removal on the right side is the same.

- Remove trim - 1 - from mounts in sun shade guide - 2 -.

- Remove bolt - 3 - (1.5 Nm).

- Remove sun shade guide - 2 - from mounts in body.

- Loosen sun shade guide - 2 - from mounts in sun shade - 4 -.





- Remove two screws - 1 - (1.5 Nm) on each holder.

- Remove sun shade - 2 - upward out of mounts.

- On vehicles with electric sun shade, disconnect wiring harness.





Installation

- To install, perform the steps used for removal in reverse order.

• Before installation, mounting elements of rear shelf must be checked for damage and replaced if necessary.