Wind Deflector

Sliding/Tilting Sunroof with Glass Panel, Meritor

Wind Deflector

Removing

- Open sunroof glass panel completely.

- Press wind deflector with height stop out of front roof opening and tilt wind deflector open vertically.





- Insert (3370) between roof edge and wind deflector bearing - arrow -.

- Pull wind deflector bearing out of side locking mechanism of left and right guide rails using (3370) in - direction of arrow -.

- Remove wind deflector upward from guide rail.

Installation

- Insert wind deflector into guide rail and slide wind deflector with height stop under front roof opening at left and right sides.

- Using light pressure, press wind deflector bearing into guide rails.

• Wind deflector bearing must engage in guide rails audibly.

Adjusting, vehicles through 08.2005

On vehicles from 08.2005, the wind deflector can be adjusted.

- Insert (3370) between roof edge and wind deflector bearing - 2 -.





- Pull wind deflector bearing - 2 - out of side locking mechanism of left and right guide rails using the (3370) in - direction of arrow a -.

- Slide wind deflector - 1 - parallel into guide rails - arrow b - until dimension - c - is adjusted between 0.3 mm and 1.3 mm.

- Press wind deflector bearing - 2 - into guide rails.

• Wind deflector bearing must engage in guide rails audibly.