Cornering Lamp: Service and Repair

HID Headlamps with Cornering Lamp Overview

• After performing work which can affect headlamp adjustment, check headlamp adjustment and adjust headlamps if necessary.





1 Cap

2 Left Cornering Lamp (L148) or Right Cornering Lamp (L149)

• Bulb H7 12V, 55 W.

• Replacing, refer to => [ HID Cornering Lamp Bulb ] Headlamps.

• Checking, refer to => [ Headlamp Range/Cornering Lamp Control Module Output Diagnostic Test Mode ] HID Headlamps.

3 Left Parking Lamp (M1) and Right Parking Lamp (M3)

• Lamp 12V, BLUE W 5 W.

• Replacing, refer to => [ HID Parking Lamp Bulb ] Headlamps.

• Checking, refer to => [ Vehicle Electrical System Control Module Output Diagnostic Test Mode ] Programming and Relearning.

4 Screws

• 2 Nm

5 Headlamp

• Removing and installing, refer to => [ Headlamps ] Headlamps

• Correcting installation position of headlamp, refer to => [ Headlamps, Correcting Installation Position ] Headlamps, Correcting Installation Position.

• Perform a basic setting.

6 Screws

• 8 Nm

7 Adjustment Bushings

• Correcting installation position of headlamp, refer to => [ Headlamps, Correcting Installation Position ] Headlamps, Correcting Installation Position.

8 Clamping Ring

9 Screws

10 Left High-intensity Gas Discharge Lamp Control Module (J343) and Right High-intensity Gas Discharge Lamp Control Module (J344)

• Removing and installing, refer to => [ HID Headlamp Control Module ] Headlamps.

11 Wire For Gas-Discharge Lamp

12 High intensity gas discharge lamp (L13) and High intensity discharge lamp (L14) (Bi-Xenon)

• Type D1S, 35 W.

• Replacing, refer to => [ HID Bulb ] Headlamps.

• Checking, refer to => [ Vehicle Electrical System Control Module Output Diagnostic Test Mode ] Programming and Relearning.

13 Left Headlamp Beam Adjustment Motor (V48) and Right Headlamp Beam Adjustment Motor (V49)

• Removing and installing, refer to => [ HID Headlamp Range Control Positioning Motor ] Headlamps.

• Checking, refer to => [ Headlamp Range/Cornering Lamp Control Module Output Diagnostic Test Mode ] HID Headlamps.

14 Cap

15 Gasket

16 Left Headlamp Power Output Stage (J667) or Right Headlamp Power Output Stage (J668)

• Removing and installing, refer to => [ HID Headlamp Power Output Stages ] Headlamps.

• After installing a new headlamp power output stage, Headlamp Range/Cornering Lamp Control Module (J745) must be coded, refer to => [ Headlamp Range/Cornering Lamp Control Module, Coding ] HID Headlamps and then basic headlamp setting performed. Refer to => Maintenance 03 Service Procedures.

17 Screws

18 Body Cross Section

19 Headlamp Range/Cornering Lamp Control Module (J745)

• Removing and installing, refer to => [ HID Headlamp Range/Cornering Lamp Control Module ] Headlamps.

• Coding, refer to => [ Headlamp Range/Cornering Lamp Control Module, Coding ] HID Headlamps.

• Output Diagnostic Test Mode (DTM), refer to => [ Headlamp Range/Cornering Lamp Control Module Output Diagnostic Test Mode ] HID Headlamps.

• Adapting, refer to => [ Headlamp Range/Cornering Lamp Control Module, Adapting ] HID Headlamps.

• If Headlamp Range/Cornering Lamp Control Module (J745) is coded, headlamp basic setting must then be performed.