HID Headlamps With Cornering Lamp Overview
HID Headlamps with Cornering Lamp Overview
• After performing work which can affect headlamp adjustment, check headlamp adjustment and adjust headlamps if necessary.
1 Cap
2 Left Cornering Lamp (L148) or Right Cornering Lamp (L149)
• Bulb H7 12V, 55 W.
• Replacing, refer to => [ HID Cornering Lamp Bulb ] Headlamps.
• Checking, refer to => [ Headlamp Range/Cornering Lamp Control Module Output Diagnostic Test Mode ] HID Headlamps.
3 Left Parking Lamp (M1) and Right Parking Lamp (M3)
• Lamp 12V, BLUE W 5 W.
• Replacing, refer to => [ HID Parking Lamp Bulb ] Headlamps.
• Checking, refer to => [ Vehicle Electrical System Control Module Output Diagnostic Test Mode ] Programming and Relearning.
4 Screws
• 2 Nm
5 Headlamp
• Removing and installing, refer to => [ Headlamps ] Headlamps
• Correcting installation position of headlamp, refer to => [ Headlamps, Correcting Installation Position ] Headlamps, Correcting Installation Position.
• Perform a basic setting.
6 Screws
• 8 Nm
7 Adjustment Bushings
• Correcting installation position of headlamp, refer to => [ Headlamps, Correcting Installation Position ] Headlamps, Correcting Installation Position.
8 Clamping Ring
9 Screws
10 Left High-intensity Gas Discharge Lamp Control Module (J343) and Right High-intensity Gas Discharge Lamp Control Module (J344)
• Removing and installing, refer to => [ HID Headlamp Control Module ] Headlamps.
11 Wire For Gas-Discharge Lamp
12 High intensity gas discharge lamp (L13) and High intensity discharge lamp (L14) (Bi-Xenon)
• Type D1S, 35 W.
• Replacing, refer to => [ HID Bulb ] Headlamps.
• Checking, refer to => [ Vehicle Electrical System Control Module Output Diagnostic Test Mode ] Programming and Relearning.
13 Left Headlamp Beam Adjustment Motor (V48) and Right Headlamp Beam Adjustment Motor (V49)
• Removing and installing, refer to => [ HID Headlamp Range Control Positioning Motor ] Headlamps.
• Checking, refer to => [ Headlamp Range/Cornering Lamp Control Module Output Diagnostic Test Mode ] HID Headlamps.
14 Cap
15 Gasket
16 Left Headlamp Power Output Stage (J667) or Right Headlamp Power Output Stage (J668)
• Removing and installing, refer to => [ HID Headlamp Power Output Stages ] Headlamps.
• After installing a new headlamp power output stage, Headlamp Range/Cornering Lamp Control Module (J745) must be coded, refer to => [ Headlamp Range/Cornering Lamp Control Module, Coding ] HID Headlamps and then basic headlamp setting performed. Refer to => Maintenance 03 Service Procedures.
17 Screws
18 Body Cross Section
19 Headlamp Range/Cornering Lamp Control Module (J745)
• Removing and installing, refer to => [ HID Headlamp Range/Cornering Lamp Control Module ] Headlamps.
• Coding, refer to => [ Headlamp Range/Cornering Lamp Control Module, Coding ] HID Headlamps.
• Output Diagnostic Test Mode (DTM), refer to => [ Headlamp Range/Cornering Lamp Control Module Output Diagnostic Test Mode ] HID Headlamps.
• Adapting, refer to => [ Headlamp Range/Cornering Lamp Control Module, Adapting ] HID Headlamps.
• If Headlamp Range/Cornering Lamp Control Module (J745) is coded, headlamp basic setting must then be performed.