HID Parking Lamp Bulb

Headlamps

HID Parking Lamp Bulb

• Function of Left Parking Lamp (M1) and Right Parking Lamp (M3) can be checked using Output Diagnostic Test Mode (DTM) of Vehicle Electrical System Control Module (J519) => [ Vehicle Electrical System Control Module Output Diagnostic Test Mode ] Programming and Relearning.

• Replacing the parking lamp bulb in a right headlamp is shown in the following illustrations.

• Replacing a left parking lamp bulb and a right parking lamp bulb is identical.

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

• During removal and installation, leave ignition key with remote control inside the vehicle to prevent the doors from locking and possibly activating the Coming Home / Leaving Home functions on its own.

- Press wire brackets - 1 - and - 2 - to the side in - direction of arrow -.





- Remove cover cap - 3 - from headlamp.

- Pull the grip piece - 1 - with parking lamp out of reflector as far as the wire lengths permit.





- Remove parking lamp - 2 - from lamp socket - 1 - in - direction of arrow -.





Installing:

Install in reverse order of removal, noting the following:

• When installing cover cap, check gasket for proper fitting. It is destroyed by entry of water into headlamp.

• Do not touch the glass of the light bulb, when installing. Your fingers will leave traces of grease on the glass which, when the light is switched on, will evaporate and cloud the glass.

- Check headlamp for function.

- Check headlamp adjustment and adjust headlamp if necessary.