Valeo Headlamp Range Control Positioning Motor

Headlamps

Valeo Headlamp Range Control Positioning Motor

• The following illustrations depict replacement of headlamp beam adjustment motor at left headlamp.

• Replacement of headlamp beam adjustment motor at right headlamp is performed analogously.

Removing:

- Remove headlamp, refer to => [ Headlamps ]. Headlamps

- Pull off cover cap - 3 -.





- Remove mounting bolt - 2 - and remove housing - 1 - completely.

- Pull out toothed gear - 1 - upward out of its installation opening.





• When removing toothed gear, make sure that the small O-ring does not get lost.

- Disconnect electrical connection - 2 -.





- Disengage headlamp beam adjustment motor - 1 - by rotating in - direction of arrow B -.

- Carefully push ball head of headlamp beam adjustment motor - arrow A - toward rear out of its guide.

- Remove headlamp beam adjustment motor - 1 - upward out of its mount.

Installing:

- Guide the headlamp beam adjustment motor - 1 - in the disengaged position completely into its mount.





- Engage headlamp beam adjustment motor - 1 - by rotating in - direction of arrow B - until it stops.





- First, carefully push ball head of headlamp beam adjustment motor - arrow A - toward rear.

- Then, carefully pull ball head of headlamp beam adjustment motor in - direction of arrow - into mount - 1 -.





• While doing this, pull reflector toward rear slightly to assist guiding the ball head into the mount.

- Reconnect connector - 2 - to headlamp beam adjustment motor.

- Insert toothed gear - 1 - into its installation opening.





- Install housing - 1 - with mounting bolt - 2 - and put on the cover cap - 3 -.





• When installing cap, ensure proper seating. It is destroyed by entry of water into headlamp.