Valeo High Beam Bulb

Headlamps

Valeo High Beam Bulb

• Left High Beam Headlamp (M30) and Right High Beam Headlamp (M32) can be checked via output Diagnostic Test Mode (DTM) of Vehicle Electrical System Control Module (J519).

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

• During removal and installation, leave ignition key with remote control inside the vehicle to prevent the doors from locking and possibly activating the Coming Home / Leaving Home functions on its own.

• In order to be able to replace high beam headlamp, it is sometimes necessary to remove neighboring components at the corresponding headlamp.

• Refer to the following tables to determine additional component removal as required, depending on engine.





* No additional work required.

• Replacing the high beam headlamp bulb in a right headlamp is shown in the following illustrations.

• Replacing a left high beam headlamp bulb and a right high beam headlamp bulb is identical.

- Pull off cover cap - 1 -.





• High beam headlamp bulb - 2 - is clipped into the reflector - 1 -.





• When removing high beam headlamp bulb - 2 -, the connector - 3 - is not disconnected first.

- Push the connector and the bulb socket in - direction of arrow - until the bulb comes loose.

- Pull the high beam headlamp bulb at the connector - 3 - out of the reflector.

- Guide the high beam headlamp bulb with the connector connected out of the headlamp housing.

- Pull the high beam headlamp bulb - 2 - off the connector - 1 -.





Installing:

• When installing cap, ensure proper seating. It is destroyed by entry of water into headlamp.

• Do not touch the glass of the light bulb, when installing. Your fingers will leave traces of grease on the glass which, when the light is switched on, will evaporate and cloud the glass.

Install in reverse order of removal, noting the following:

- Guide high beam headlamp into headlamp housing.

- Push high beam headlamp into reflector to its installation position as depicted in the illustration.





• High beam headlamp must engage audibly.

- Connect the connector - 2 - to the high beam headlamp bulb - 1 -.





- Check headlamp for function.

- Check headlamp adjustment and adjust headlamp if necessary.