Horn: Service and Repair

Horns

• High Tone Horn (H2) and Low Tone Horn (H7) are activated in parallel by Vehicle Electrical System Control Module (J519).

• Removal and installation procedure for both horns is the same.

• High Tone Horn (H2) is installed at left and Low Tone Horn (H7) is installed at right, next to radiator.

Removing:

- Turn off the ignition and all electrical consumers.

- Remove noise insulation.

- Disconnect electrical connection - 2 -.





- Remove the mounting bolt - 1 - and remove signal horn - 3 - with bracket.

Installing:

- Install in reverse order of removal, noting the following:

- Tighten the fasteners to the specification shown in => [ Specifications ] Table of Contents.