Front Turn Signals

Front Turn Signals

• Illustrations depict removal and installation of left turn signal. Removal of right turn signal is performed symmetrically in the same way.

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

• During removal and installation, leave ignition key with remote control inside the vehicle to prevent the doors from locking and possibly activating the Coming Home / Leaving Home functions on its own.

- Remove the mounting bolt - 1 - and unclip cover - 2 - at locking mechanism - arrow - from bumper cover.





- Remove mounting bolt - arrow - on underside of turn signal.





- Pull turn signal - 1 - out of bumper cover while paying attention to the lengths of the connected wires.

- Disengage and disconnect harness connector - 1 - and remove turn signal - 2 - together with the clipped-on protective strip.





- Using a suitable screwdriver, release locks - arrows - and remove clipped-on protective strip - 2 - from turn signal - 1 -.





Installing:

Install in reverse order of removal, noting the following:

• When installing protective strip onto turn signal housing, make sure that all retaining lugs engage correctly.