Front Suspension

Fastener Tightening Specifications





• 1 Always replace after removal.

• 2 Tighten only in curb weight position. Refer to => [ Wheel Bearing, Lifting to Curb Weight Position ] Procedures.

• 3 Pre-tighten to 100 Nm, then loosen by 180° and tighten to 100 Nm again.

• 4 Pre-tighten all nuts to 10 Nm.

• 5 Pre-tighten to 10 Nm in a diagonal sequence, then tighten to tightening specification in a diagonal sequence.