Releasing and Disassembly Contact Housings

Releasing and Disassembly Contact Housings

• Observe general notes for repairs on the vehicle electrical system. Refer to => [ Vehicle Electrical System ] [1][2]Description and Operation.

• Always use the release tools intended for the releasing process. Under no circumstances may terminals be pulled forcefully out of terminal housings.

• Damaged contact housings must always be replaced. New contact housings may be ordered via OTC Kassel.

• Small screwdrivers may be used as an aid to release the secondary locks.

• Chamber/pin assignment is located partially stamped in on secondary lock or rear side of terminal housing.

• Detailed information on component locations of harness connectors.

The application of the correct release tools to the respective locks can be found in the table in user instructions for VAS 1978/35.