HID Headlamp Control Module

Headlamps

HID Headlamp Control Module

• Left High-intensity Gas Discharge Lamp Control Module (J343) and Right High-intensity Gas Discharge Lamp Control Module (J344) is not capable of On Board Diagnostic (OBD).

• Illustrations depict replacement of High-intensity Gas Discharge Lamp Control Module at right headlamp.

• Replacement of Left High-intensity Gas Discharge Lamp Control Module and of Right High-intensity Gas Discharge Lamp Control Module is identical.

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

- Remove headlamp, refer to => [ Headlamps ]. Headlamps

- Remove mounting bolts - arrows - and pull High-intensity Gas Discharge Lamp Control Module - 1 - as far from headlamp as wire lengths allow.





- Release the tab - arrow A - on the connector - 1 - and remove connector - 1 -.





- Release retainer - 3 - on connector - 2 - in - direction of arrow B - and remove connector - 2 -.

Installing:

CAUTION!
Make sure seals have proper seating when installing High-intensity Gas Discharge Lamp Control Module. It is destroyed by entry of water into headlamp.

Install in reverse order of removal, noting the following:

- Check headlamp for function.

- Check headlamp adjustment and adjust headlamp if necessary.