Exterior Rearview Mirror

Exterior Rearview Mirror

Turn Signals

• The following describes removing and installing the left turn signal. Removing and installing the right turn signal is identical.

• LEDs with a long service life are installed in the side turn signals instead of standard bulbs.

• Because of that, it is not necessary to replace bulbs. If there is damage, the entire turn signal assembly must be replaced.

Removing

- Remove mirror glass. Refer to => [ Mirror Glass ] Mirror Glass

- Remove mirror housing. Refer to => [ Mirror Housing ] Mirror Housing

- Remove trim. Refer to => [ Trim ] Trim





- Remove screws - 4 - and remove assembly piece - B - downward.

- Disconnect harness connector - 5 - from turn signal - 3 -.

- Remove screws - 2 - and remove turn signal - 3 - from assembly piece - 1 -.

Installation

To install, perform the steps used for removal in reverse order.

• Then perform a function test.