Controls, Housing
Special Tools
Special tools, testers and auxiliary items required
• Adapter (10 - 222 A/18)
• Transmission Support (3282)
• Engine Support Device (3300 A)
• Support (T10036 A)
• Support (T10036)
• Holding Plate (VW 309)
• Transmission Support (VW 353)
• Driving Sleeve (VW 244 B)
• Hot Air Blower (V.A.G 1416)
• 2-Arm Puller (20/10)
• Support Bridge (T10323)
• Wheel Bearing Assembly Set (3253/7)
• Thrust Pad Con.8/65 (VW 433)
• Thrust Piece (40 -105)
• Puller (T10408)
• Seal Installer Set - Rear Diff (3066)
• Thrust Pad (3124)
• Slide Hammer-Complete Set (VW 771)
• Additional Part for VW 771 (VW 771/37)
• Connecting Pin (T10027 A)
• Hose Clamp Pliers (V.A.G 1275)
• Plate (T10419)
• Shackle (10-222 A/12)
• Thrust Block (T10083)
• - 2 -Kukko Puller 65-160 mm (Kukko 18/1)
• Thrust Piece (T10148)
• Thrust Piece (T10203)
• Sleeve (VW 423)
• Pry Lever-Rmv Outside Mirror (80–200)
• Assembly Mandrel (10 - 508)
• Spring Strut Compressor (2070)
Special tools, testers and auxiliary items required
• Engine Support Bridge (10 - 222 A)
• Engine Support Feet (10 - 222 A/ 8)
• Additional Hooks ( 10 - 222 A/2)
• Engine Support Adapter (10 - 222 A/3)
• Transmission Support (3282)
• Adapter (10 - 222 A/16)
Special tools, testers and auxiliary items required
• Adjustment Plate (3282/39)
• Transmission mounting elements, (when mounting the adjusting plate on the transmission support)
• Engine/Transmission Jack (V.A.G 1383A)
• Torque Wrench (5-50 Nm) (V.A.G 1331)
• Torque Wrench (40-200 Nm) (V.A.G 1332)
• Transmission Support Jig (3336) for transporting the transmission
• Grease for clutch shaft splines (G 000 100)
Special tools, testers and auxiliary items required
• Bracket (30-211A)
• Driving Sleeve (32 -111)
• Thrust Piece (T10030/4)
• Tube 37 mm Dia. (VW 416 B)
• Puller (T10309)
• Two-Arm Puller (T10040)
• Puller Legs with Thrust Piece (T10040/2A + /3)
Special tools, testers and auxiliary items required
• Needle Bearing Drift (VW 295)
• Needle Bearing Drift (VW 295 A)
• Thrust Pad (VW 447 H)
• Thrust Pad (VW 512)
• Press Tube (2040)
• Thrust Tube (VW 454)
Special tools, testers and auxiliary items required
• Thrust Plate (VW 402)
• Thrust Piece (3290/1)
• Assembly Tool (3301)
• Thrust Pad 16.5/28 mm Dia. (VW 431)
• Sleeve (VW 472/2)
• Drift (10 - 206)