Headlamps

Halogen Headlamps, from 12.06


Headlamps

• It is not necessary to disconnect battery.

• Illustrations depict removal and installation of right headlamp.

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Disengage and disconnect harness connector - 1 -.





- Tip locking lever - 1 - in direction of arrow.

Headlamp locking lever - 1 -





- To tip headlamp - 1 -, press inward in - direction of arrow - with balls of hands in rear area.





- Pull the headlamp - 1 - straight forward in the - direction of the arrow - out of the opening in the body.





Installing

Install in reverse order of removal, noting the following:

CAUTION!
• After installing and locking the headlamp with the lever --> [ Headlamp locking lever ] - 1 -, press sideways on the headlamp housing to make sure the headlamp is locked securely.

• If the headlamp is locked but it still turns when pressed on the side, it is installed incorrectly.

• If that is the case, repeat the installation procedure until the headlamp is locked securely.

- Check installation position of headlamp for uniform gap dimensions.

If headlamp has an uneven gap dimension to the body, installation position must be corrected --> [ Headlamps Correcting Installation Position ] Procedures.

- Check headlamp for function.

- Check and adjust headlamp aim if necessary .