Rear Lid Tail Lamps

Tail Lamps


Rear Lid Tail Lamps

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Open rear lid.

- Clip service cover - 1 - out of locking mechanisms and pull off cover in - direction of arrow -.





- Disconnect connector - arrow -.





- Remove mounting nuts - 1 - and remove housing for tail lamp assembly.

Installing

Install in reverse order of removal, noting the following:

- Bring housing for tail lamp assembly into correct position to the body by hand, hold firmly and then tighten mounting nuts.

- Tighten the nuts to the tightening specification --> [ Tail Lamps ] Tail Lamps.

- Check gap dimension of tail lamp assembly --> [ Tail Lamp Gap Dimensions ] Tail Lamp Gap Dimensions.