Ignition, Assembly Overview

Ignition, Assembly Overview







1 - Ignition coil with power output stage N70, N127, N291, N292, N323, N324
- Remove and install using Puller For Ignition Coil T10095 A
2 - Connector
- Black
- Use assembly tool T10118 to pull off
3 - Bracket
- For harness connector of Knock Sensor (KS) 1 G61
4 - 20 Nm
5 - Connector
- Black, 3-pin
- Terminals of sensor and connector are gold-plated
6 - Knock Sensor (KS) 1 G61
- Component location: Cylinder block, exhaust side
7 - 20 Nm
- Tightening torque affects function of Knock Sensor (KS)
8 - Exhaust camshaft adjuster
- Identification: 32 A
- With sensor wheel for Camshaft Position (CMP) Sensor 2 G163
- If camshaft adjuster has been removed, adjust valve timing after installation.
9 - Cover
10 - Connector
- Black, 3-pin
- Terminals of sensor and connector are gold-plated
11 - 10 Nm
12 - Camshaft position (CMP) sensor 2 G163
- For exhaust camshaft
- Terminals of sensor and connector are gold-plated
13 - Seal
- Replace
14 - Camshaft Position (CMP) sensor G40
- For intake camshaft
- Terminals of sensor and connector are gold-plated
15 - Knock Sensor (KS) 2 G66
- Component location: Cylinder block, intake side
- Terminals of sensor and connector are gold-plated
16 - Connector
- Black, 2-pin
- Terminals of sensor and connector are gold-plated
17 - Intake camshaft adjuster
- Identification: 24E
- With sensor wheel for Camshaft Position (CMP) Sensor G40
- If camshaft adjuster has been removed, adjust valve timing after installation.
18 - Spark plug, 20 Nm
- Removing and installing with spark plug removal tool 3122B
- Type and electrode gap
19 - Control housing
- For camshaft adjustment