Safety Precautions

Safety Precautions

To reduce the risk of personal injury and/or damage to the fuel injection and ignition system, always observe the following:

• The ignition must be switched off before connecting or disconnecting injection and ignition system wiring or tester cables.

• Do not touch or remove ignition wires when engine is running or turning at starter speed.

Observe the following if test and measuring instruments are required during a test drive:

• Test and measuring instruments must be secured to rear seat and operated by a 2nd person from this location.

If test and measuring instruments are operated from the front passenger's seat and the vehicle is involved in an accident, there is a possibility that the person sitting in this seat may receive serious injuries when the airbag is triggered.

• If engine is to be cranked at starting RPM without starting:

- Remove the ignition coil wiring harness cover strip - in direction of arrows -.





- Disconnect harness connectors from ignition coils 1 to 6 using assembly tool (T10118).

- To do so, place assembly tool (T10118) on locking button - arrow - and carefully pull down harness connector.





- Remove fuel pump fuse from fuse holder.