Torque Specifications
Torque Specifications
Torque specifications:
Cylinder Head Bolts
Note: Longer bolts must be inserted in middle holes of cylinder head.
- Tighten new cylinder head bolts in tightening sequence from inside to outside as follows.
First pass: Tighten new bolts 15 Nm
Second pass 30 Nm
Final pass: Tighten all bolts (1/2 turn) (180°) further
Camshaft Bearing Cap Nuts
Please refer to Camshafts, Removing and Installing for tightening
specifications and procedure. Camshafts
Crankshaft Main Bearing Cap Bolts 30 Nm plus an additional 1/2 turn (180°)
Two 90° further turns is permitted
Replace bolts
Connecting Rod Bolts 30 Nm plus an additional 1/4 turn (90°)
Replace
Vibration Damper Bolt 100 Nm plus an additional 1/2 turn (180°)
Replace
Drive Plate Bolts
First pass Hand tighten new bolts
Final pass 60 Nm plus an additional 1/4 turn (90°) (turning further may be performed in several steps)
Oil Pump Mounting Bolts 8 Nm
Use new bolts
Coolant Pump Bolts 8 Nm