Tightening Torque & Sequences
CYLINDER HEADLeft Cylinder Head Cover Bolt Tightening Sequence and Specification
Tighten the left cylinder head cover bolts - 1 through 15 - in the sequence shown to 9 Nm..
Right Cylinder Head Bolt Tightening Sequence and Specification
Tighten the left cylinder head cover bolts - 1 through 16 - in the sequence shown to 9 Nm..
Cylinder Head Bolt Tightening Sequence and Specification
Tighten the cylinder head bolts - 1 through 10 - in 4 passes in the sequence shown as follows:
First pass, tighten to 30 Nm using a torque wrench.
Second pass, tighten to 60 Nm using a torque wrench.
Third pass, tighten to 90° (1/4 turn) additional turn using a wrench.
Final pass, tighten to 90° (1/4 turn) additional turn using a wrench.
Insert bolts - arrows - with locking compound and tighten to 8 Nm.
Tighten bolts - arrows - an additional 90° (1/4 turn) using a wrench.
CAMSHAFT BEARING CAP
Camshaft Bolt 80 Nm + 90 degrees turn
ROD BEARING CAP
Connecting rod bolt - 60 Nm + 90° (1/4 turn)
FLYWHEEL/FLEX PLATE
Drive Plate to crankshaft Bolt 1, 2 5 Nm + 90 degrees turn
CRANKSHAFT PULLEY
Vibration Damper to Crankshaft Bolt 1 22 Nm + 45 degrees turn
OIL PUMP
Oil Pump to cylinder block bolt 3 8 Nm + 90 degrees turn
WATER PUMP
Coolant Pump to Coolant Pump Housing bolt 9 Nm