Rear Lid Seal

Rear Lid Seal

The seal on the rear lid is equipped at the factory with a sealant, applied to body flange and then rolled on.

• The sealing compound will be distributed on the inside of the seal and the flanks will be slightly bent when the seal is removed. When the seal is installed again, it may not fit securely and it make leak.

• For this reason, every completely removed seal must be replaced with a so-called "hammer-stroke seal".

• For partially removed seals, seal flanks must be pressed together before installation.

Removing






- Remove rear lid gasket - 1 - from body flange - 3 -.

Installing






Body flange - 3 - is taped in lower area with commercially available fabric adhesive tape - 4 -.

- Guide the left and right gasket into the window shaft strip - 2 -.

- Attach the weather seal - 1 - to the body flange.