Intake Manifold Overview

Intake Manifold Overview






1 Nut

• 10 Nm

2 Clamp

3 Bolt

• 3 Nm

4 Stud Bolt

• 10 Nm

5 Gasket

• Always replace

6 Intake Manifold

• With the intake manifold flaps.

• Removing and installing, refer to => [ Intake Manifold ] Intake Manifold.

7 Coupling Rod

8 Intake Flap Motor (V157) with Intake Manifold Runner Position Sensor (G336)

• Removing and installing, refer to => [ Intake Flap Motor (V157) with Intake Manifold Runner Position Sensor (G336) ] Service and Repair.

9 Bolt

• 7 Nm

10 to the Evaporative Emission (EVAP) Canister

11 Hose

12 EVAP Canister Purge Regulator Valve 1 (N80)

13 Hose

14 Double Check-Valve

• Checking, refer to => [ Double Check-Valve, Checking ] Testing and Inspection.

15 Intake Manifold Support

16 Bolt

• 25 Nm

17 Nut

• 10 Nm

18 Bonded Rubber Bushing

19 Throttle Valve Control Module (J338)

• With the Electronic Power Control (EPC) throttle drive (G186) , EPC throttle drive angle sensor 1 (G187) and EPC throttle drive angle sensor 2 (G188).

• Removing and installing, refer to => [ Throttle Valve Control Module (J338) ] Removal and Replacement.

20 Bolt

• 7 Nm

21 Seal

• Replace if damaged.

22 Bolt

• 5 Nm

23 Intake Air Temperature Sensor (G42)

24 Bolt

• 10 Nm