Tires, Mounting

Tires, Mounting


• Pay attention to the instructions for warming-up cold tires to the minimum mounting temperature. Refer to => [ Wheels and Tires, Mounting Assembly Requirements ] Wheels and Tires, Mounting Assembly Requirements.

• Note the safety precautions. Refer to => [ Run-Flat Tires Safety Precautions ] Service Precautions.

• When changing a tire, it is recommended to change the tire pressure sensor seals at the same time.

- Coat rim flanges, tire beads and inside of upper tire beads thoroughly with tire mounting paste.

- Install the inner side of the tire first

- Turn the disc wheel on tire mounting device so that valve/tire pressure sensor - arrow - is opposite to the mounting head.






- Push the tires between the tire valve/tire pressure sensor and the mounting head into the bed - direction of arrow -.

- Let the tire dismounting/mounting machine run clockwise.

- Mounting of the lower bead ends before the tire valve/tire pressure sensor to prevent damage to tire pressure sensor.

• Tire bead now slips over the rim flange. Wheel may be turned only as far until mounting head is located just in front of tire valve/tire pressure sensor.

- Make sure tire bead fits correctly on mounting head and let mounting device run clockwise.

- Mounting of the upper bead ends before the tire valve/tire pressure sensor to prevent damage to tire pressure sensor.

• Tire bead now slips over the rim flange. Wheel may be turned only as far until mounting head is located just in front of tire valve/tire pressure sensor.

- Inflate tire to an inflation pressure of max. 3.3 bar (spring pressure).


If tire beads do not make contact completely on disc wheel edge, pressure must not be increased under any circumstances.

Pre-damage to tire or disc wheel would result.

- If tire beads do not make contact completely on disc wheel edge, then release air, press off tire bead once more and coat rim flange thoroughly again with tire mounting paste.

- Inflate tire to an inflation pressure of max. 3.3 bar (spring pressure).

- If tire beads make contact on bead seat without problems, then increase inflation pressure to 4 bar to settle tire.

- Install a new nickel-plated valve insert and fill the tire to the specified pressure.

- Then balance wheel.

- Mount the wheel and tighten it to tightening specification. Refer to => [ Wheel Bolts Tightening Specification ] [1][2]Specifications.