Power Lumbar Support

Power Lumbar Support

Removal and installation of lumbar support is described for left backrest frame. The same removal and installation instructions for lumbar support apply for right backrest frame.

Removing

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Remove front seat. Refer to => [ Front Seat ] Front Seat

- Attach the seat to the fixture for seat repair (VAS 6136).

- Remove the trim from on the tunnel side from the seat. Refer to => [ Seat Trim, Tunnel-Side ] Seat Trim, Tunnel-Side

- Remove the trim on the sill-side from the power seat. Refer to => [ Power Seat Sill-Side Trim ] Power Seat Sill-Side Trim

- Remove front seat backrest. Refer to => [ Left Front Seat Backrest ] Left Front Seat Backrest

- Secure backrest on fixture for seat repair (VAS 6136).

- Remove cover and upholstery from front seat backrest. Refer to => [ Front Seat Backrest Covers and Upholstery ] Front Seat Backrest Covers and Upholstery

- Remove front side airbag. Refer to => [ Driver and Passenger Side Airbag ] Driver and Passenger Side Airbag

- Disconnect wiring harness from drive motors - 1 - and - 2 -.

- Drill out rivet - 3 - in lower area on rear side.

- Drill out two rivets - 4 - on left side.

- Drill out two rivets - 5 - on right side.

- Disengage lumbar support from mounts in backrest frame - arrows -.

- Remove components of lumbar support from backrest frame.






Installation

- Install in reverse order of removal.

To install rivets - 3 -, - 4 - and - 5 -, use pop rivet pliers (VAS 5072).