Left Rear Level Control System Sensor (G76)

Left Rear Level Control System Sensor (G76)

Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Disconnect connector - arrow -.






- Remove mounting bolts - 1 - and remove Left Rear Level Control System Sensor - 2 -.






Installation

Install in reverse order of removal, noting the following:

- Tighten all threaded connections to the specification. Refer to => [ Level Control System Sensor, Tightening Specifications ] Level Control System Sensor, Tightening Specifications.

- Check Left Rear Level Control System Sensor. Refer to => [ Level Control System Sensor, Checking ] Level Control System Sensor, Checking.

- Perform basic setting of headlamp.

• If the vehicle level sensors are replaced, the values of the sensor must be checked. Refer to => [ Level Control System Sensor, Checking ] Level Control System Sensor, Checking and basic setting of headlamps must be performed.

• If values of vehicle level sensors are outside the tolerance range, basic setting of headlamps cannot be performed.