Shift Unit Overview

Shift Unit Overview

• Lubricate the bearing areas and sliding surfaces.






1 Nut

• Removing and installing, see => [ (Item 17) Nut, Self Locking ] Shift Mechanism Overviews.

2 Transmission Shift Lever

• Can be replaced with the shift mechanism still installed.

• Installed position, refer to => [ Selector Lever/Relay Lever, Installed Position ] Shift Mechanism Overviews.

• Installing, refer to => [ Transmission Shift Lever, Installing ] Shift Mechanism Overviews.

• Adjust the shift mechanism after installation. Refer to => [ Shift Mechanism, Adjusting ] Adjustments.

3 Sliding Shoe

• Clipped onto the relay lever.

4 Bushing

• Not needed with the plastic relay lever.

5 Relay Lever

• Installed position, refer to => [ Selector Lever/Relay Lever, Installed Position ] Shift Mechanism Overviews.

• Adjust the shift mechanism after installation. Refer to => [ Shift Mechanism, Adjusting ] Adjustments.

• Plastic as of 03.07. Refer to => [ Plastic Relay Lever ] Plastic Relay Lever.

6 Gear Shift Unit

• Consisting of the shift shaft and the shift cover.

• The components cannot be separated from each other.

• Can be removed and installed with the transmission installed.

• Shift shaft adapted together with the revised reverse gear selector fork => [ (Item 5) Reverse Gear Selector Fork ] Shift Forks.

• Allocation, shift shafts, refer to => [ Shift Shaft Allocation ].

7 Bushing

• For the shift shaft.

• Removing and installing, see => [ (Item 16) Bushing ] Transmission Housing.

8 O-ring

• Insert in the groove in the shift cover.

• Install using transmission fluid.

• Always replace.

9 Cap

• For the transmission ventilation.

10 Circlip

• For the relay lever.

• Not needed with the plastic relay lever.

11 Selector Shaft Seal

• Removing and installing, refer to => [ Selector Shaft Seal ] Selector Shaft Seal.

Shift Shaft Allocation