Removal and Replacement

Breather Assembly

Removing and Installing the Line - 4 - to the Breather Assembly - 1 -:





- Pull out the clip - 2 - with a screwdriver or a pointed tool and remove the line - 4 - from the breather assembly - 1 -.

- Push the line - 4 - with the O-ring - 3 - into the breather assembly - 1 - until the clip - 2 - engages audibly.

- Pull on the line to make sure it is secure.

Removing and Installing the Breather Assembly - 4 - from/to the Slave Cylinder:





- To remove, pull out the clip - 2 - with a screwdriver or a pointed tool and remove the breather assembly - 4 - from the slave cylinder - 1 -.

- Check the O-ring - 3 - on the clutch slave cylinder. Press in the breather assembly at the slave cylinder connector until the clip - 2 - engages audibly.

- To check, pull on the breather assembly.

- Bleed the clutch system. Refer to => [ Clutch System, Bleeding ] Procedures.