Glass Panel Cables, Installing

Glass Panel Cables, Installing






- Guide glass panel cables - 2 - into rear guide rails.

- Insert glass panel cables - 2 - in guide rail mount - 3 -.

• The - arrow - points to the direction of travel.






- Place sunroof motor - 2 - in mount on guide tube - 4 -.

- Install 3 bolts 3- 3 -, tightening specification 4.5 Nm.

- Crank glass panel back as far as "stop" using emergency operation.

- Position sliding blocks on applied markings and tighten screws. Tightening specification: 9.5 Nm.

- Close the CSC roof and remove the hinge supports (VAS 6365).

- Install the intermediate shaft and the sunroof motor.

- Install the tensioned headliner and loosened tensioning cable.

- Adapt sunroof motor. Refer to => [ Sunroof Motor, Installing ] Sunroof Motor, Installing