Sunroof Motor, Installing

Sunroof Motor, Installing

• The sunroof motor is equipped with a closing force limit. If the roof runs into an obstacle during the closing procedure, the motor stops and the glass panel moves in the opposite direction.

• If the glass panel is closed a second time with the switch, it runs with increased closing force. If the glass panel still runs into an obstacle, it runs once again in the opposite direction.

• If the glass panel is closed a third time using the switch, it runs without a closing force limit.

• All screws are microencapsulated and must always be replaced.






- Place sunroof motor - 2 - on mount - 4 - and tighten screws - 3 -. Tightening specification: 4.5 Nm.

Both a re-installed sunroof motor and a new sunroof motor must always be adapted.

• Pull switch, glass panel - 1 - closes.

• Pull switch a second time, glass panel closes with increased closing force.

• Pull switch a third time, glass panel closes without closing force limit.

In this way, the sunroof motor is adapted and learns the zero position.

- Install tensioned headliner rail. Refer to => [ Tensioned Headliner Rail, Installing ] Tensioned Headliner Rail, Installing.

- Install the tensioned headliner. Refer to => [ Tensioned Headliner, Installing ] Tensioned Headliner, Installing.