Defroster Door Motor (V107)

Defroster Door Motor (V107)

Special tools, testers and auxiliary items required

• Vehicle Diagnosis, Testing and Information System (VAS 5051B) (or succeeding model)

Perform the following work first:

- Turn off all electric consumers.

- Switch off the ignition.

- Remove the key.

Removal

- Remove the instrument panel.

- Remove the left footwell vent. Refer to => [ Left Footwell Vent ] Left Footwell Vent.

- Remove the Data bus on board diagnostic interface (J533).






- Remove the bolts - 1 - and - 3 - (9 ± 1.3 Nm).

- Remove the bracket - 2 -.






- Mark the connector - C - for the motor (danger of confusing it with other connectors that may look the same).

- Disconnect the connector - C - from the defroster door motor (V107).

- Remove securing bolts - A - and remove defroster door motor - B -.

- Disconnect the lever - E - from the connecting rod - D -.

Installation

Install in reverse order of removal.

• After installing, function of defroster door must be checked.

• Start the Basic Setting function with Vehicle Diagnosis, Testing and Information System (VAS 5051B). Refer to=> [ Checking and Adjusting Components ] Checking and Adjusting Components.