Battery, Transmitter and Receiver Unit, Fuse and Wiring Harness, Overview

Battery, Transmitter and Receiver Unit, Fuse and Wiring Harness, Overview






1 - Positive Connection

• red wire with suitable connection

2 - To Terminal 15a

• Connection to terminal 15a.

• Ensure wire is protected by fuse.

• Fuse maximum 15 amps.

3 - Antenna Ground

• Make sure the ground is connected to the body properly.

• Antenna location must be treated with suitable corrosion protection.

4 - Transceiver Antenna

• Installation locations, refer to => [ Transmitted Output, Antenna Installation Locations ] Specifications.

5 - Shielded Antenna Wire

• Wire with coaxial connector.

6 - Telephone Or Two-Way Radio Transceiver

7 - Wiring Harness

• Voltage supply positive via red wire, 2.5 mm2 cross section.

• Voltage supply negative via brown wire, 2.5 mm2 cross section.

• If necessary, wire to terminal 15a via black wire 1.5 mm 2 cross section.

8 - Fuse Holder

• Install next to battery.

9 - To Starter

10 - Battery

• Installation location in engine compartment.

11 - Negative Wire

12 - Body Ground